Standard Instructions of Pasting Ricon Head Flat Cables
A:
First a non-dust desk surface and tools below are needed (seen photo 2-1). The print head must be handled with care.
1. 1x scissors
2. A number of print heads
3. 1x single-side adhesive 3J
4. 1x duct tape (100mm )

B:
To cut our and paste with single-side adhesive
1.
First cut out 320mm-long single-side adhesive, similar to the length of the flat cables (Seen 2-2 2-3 ).


2.
Second, tear the single-side adhesive, put on the desk surface, and paste the print head flat cable on it(Seen 2-4). Smooth adhesive is necessary.

3.
Third, fold the flat cable to be pasted another surface .

4.
While pasting, the way to hold the print head is suggested as Photo 2-8.

C:
To cut out and paste with duct tape
1.
First, paste onto the duct tape and cut out proper length (Seen 2-9).

2.
Second, fold and paste from the middle part to the side. No obvious distortion (Seen 2-10).

3.
Third, fold and paste the rest part. The total length should be longer than single-side adhesive to make it full covered (Seen 2-12).
